Bleeder Cloth in Vacuum Bagging: How to Choose the Right Fabric for a Clean Laminate
Share
Bleeder Cloth in Vacuum Bagging: How to Choose the Right Fabric for a Clean Laminate
Bleeder cloth is one of the most important consumables in a vacuum bag, and one of the most misunderstood. Choose the right one and your laminate comes out with a consistent surface, a good fibre-to-resin ratio and few voids. Choose poorly and you get resin starvation, dry spots or a bag that never pulls down evenly. This guide explains what bleeder cloth does, how it differs from peel ply and release film, and how to pick the right fabric for your layup.
What bleeder cloth does in a vacuum bag
Bleeder cloth sits between the laminate and the vacuum bag. It gives excess resin a path to escape, and it gives trapped air and volatiles a route to the vacuum port. Without it, the bag can seal off resin pockets and leave the laminate resin-rich in some areas and starved in others.
Bleeder, peel ply and release film: what each one controls
- Bleeder cloth controls resin content and airflow. It absorbs excess resin and keeps the vacuum path open.
- Peel ply creates a textured, bondable surface. It is removed after cure, leaving a clean surface for secondary bonding or painting.
- Release film separates the laminate from the bleeder or peel ply. It controls how the layers come apart and stops them bonding to each other.
Most layups use all three, stacked in that order against the part.
Choosing bleeder weight and absorption
The right bleeder depends on how much resin you need removed and how fast the resin is moving.
- Lighter bleeders absorb less resin and suit low-resin-content layups or thin parts.
- Heavier bleeders absorb more resin and suit wet layups where you want a lower resin content.
- Check the fabric's data sheet for its resin absorption and airflow characteristics before you commit, and test on an offcut if you are unsure.
As a rule, match the bleeder to the part. Over-bleeding a thin part can starve it, while under-bleeding a thick part can trap resin and air.
Setting up the bag: layer order and airflow
- Lay up the laminate on a clean, sealed mould with release agent applied.
- Place the release film over the laminate, taking care to avoid wrinkles.
- Add the bleeder cloth in a single, even layer, extending beyond the part edge.
- Add the breather or vacuum channel if your setup needs one, so air can reach the port.
- Seal the bag with tacky tape and check for leaks before applying full vacuum.
Keep the bleeder continuous across the part so the vacuum path is not blocked.
Common mistakes that cause dry spots or resin starvation
- Using the wrong weight for the resin content you need.
- Gaps or overlaps in the bleeder that block airflow or create resin pockets.
- Wrinkles in the release film that transfer to the laminate surface.
- Skipping a leak check, which can slow the pull and trap air.
- Reusing bleeder that is saturated with resin, which no longer absorbs or breathes properly.
Cleaning up and reusing materials
Dispose of resin-saturated bleeder after each cure, as it rarely cleans to a reliable standard. Release film and peel ply are usually single-use. Keep unused rolls dry and out of direct sun so the fabric stays stable.
Frequently asked questions
Can I use peel ply instead of bleeder cloth? Not in most cases. Peel ply gives a textured surface but does not reliably manage resin flow or airflow. Use bleeder cloth for resin control and peel ply for surface prep.
Do I need bleeder on every vacuum bag? Not always. Some simple layups with low resin content can run without it. For most wet layups, bleeder helps achieve a consistent result.
How do I know if I am over-bleeding? If the laminate looks resin-starved, with dry fibres or a matt finish in places, the bleeder may be absorbing too much resin for that layup.